This DIY light switch guard will save you that frustration. Sure, you could just slap an ugly piece of tape over the switch. You could also open up the switch plate and disable it altogether.

If the wires aren’t tightened under screw terminals, but instead are pushed into holes in the back of the switch, here’s how to release the wires: Look for a small square hole directly below ...

If you do have this wire, Donnelly says to attach it to the green screw, which will be on your light switch. Step 5: Replace the switch plate Use a screwdriver to place the switch plate back on ...

5. Connect your outlet. Strip the ends of your wires clean to about ¾ on an inch and attach the black wire that goes to the light switch and a black jumper wire to the power source with a wire nut.